Instruction Manual - Beta Industries

More documents

Recommendations

Info

Change to characteristic curve display Device Settings 3 3.2.3.2 Move the sub-cursor Shift the sub-cursor from left to right Shift the sub-cursor from right to left Shift the sub-cursor downwards / Decrease value Shift the sub-cursor upwards / Increase value 3.2.3.3 Device Settings Standard plate Polyester plate Paper Film Screen ruling in (lines/cm) 19/49
Screen ruling in (lines/inch) Regular screening (AM) Stochastic screening (FM). Illumination for plate measurement R (Red LED), G (Green LED), B (Blue LED) Color for paper measurement C (Cyan LED), M (Green LED), Y (Blue LED), K (Green LED) Automatic CMY color recognition during paper measurement Positive dot % Negative dot % 20/49
Page 1 and 2: UltraDottie II CTP Calibrator Opera
Page 3 and 4: 1 TABLE OF CONTENTS 3 2 GENERAL 5 2
Page 5 and 6: 3.8 UltraDottie IIII MAINTENANCE AN
Page 7 and 8: 2 General 2.1 Introduction Dear Bet
Page 9 and 10: 2.2 Safety 2.2.1 Warning For safety
Page 11 and 12: 2.3 Packaging and transport Always
Page 13 and 14: 2.5.2 Beta Target (Optional) The Be
Page 15 and 16: 3.8 UltraDottie IIII MAINTENANCE AN
Page 17 and 18: 3.2 First steps for use Release the
Page 19: uttons (see section 3.1). The funct
Page 23 and 24: Screen angle in ° Logarithmic Refl
Page 25 and 26: • Unit displayed (cm or inch) •
Page 27 and 28: on the X axis of the diagram. After
Page 29 and 30: symbol, the measurement must be rep
Page 31 and 32: 33.5.2 Calibration As the UltraDott
Page 33 and 34: transmission mode. This is why no c
Page 35 and 36: 3.5.7.3 Dot diameter The diameter o
Page 37 and 38: 3.6 Visually checking the dot After
Page 39 and 40: 3.7 Measuring a plate characteristi
Page 41 and 42: Example: Measuring a plate characte
Page 43 and 44: 3.8 UltraDottie II maintenance and
Page 45 and 46: 4 APPENDIX 35 4.1 TECHNICAL DATA 37
Page 47 and 48: Measurement technique Sensor CMOS 6
Page 49 and 50: 4.2 Serial interface The UltraDotti

Instruction Manual - Beta Industries

Create successful ePaper yourself

Delete template?

Save as template?