Instruction Manual - Beta Industries

More documents

Recommendations

Info

3.5.7.5 Visual Coverage The visual coverage is a ‘density’ measurement, which is not compatible with any current density standard and can only be used for comparative analysis. For proper density measurements, we recommend using a <strong>Beta</strong> <strong>Industries</strong> Densitometer conforming to standards. For the “Visual Coverage” value, a zeroing on the medium is needed. The zeroing is done by a measurement on the sample (e.g. plate background). 35/49
3.6 Visually checking the dot After a measurement the picture will be held in the device’s memory until the next measurement and can be displayed or transferred to a host computer at any time by selecting the function . As usual you will find the toolbar on the left side of the LCD with the following functions. Increase representation resolution to 12,700 ppi Reduce representation resolution to 6350 ppi Transfer the current binary image to the host PC via RS232 Back to previous display 36/49
Page 1 and 2: UltraDottie II CTP Calibrator Opera
Page 3 and 4: 1 TABLE OF CONTENTS 3 2 GENERAL 5 2
Page 5 and 6: 3.8 UltraDottie IIII MAINTENANCE AN
Page 7 and 8: 2 General 2.1 Introduction Dear Bet
Page 9 and 10: 2.2 Safety 2.2.1 Warning For safety
Page 11 and 12: 2.3 Packaging and transport Always
Page 13 and 14: 2.5.2 Beta Target (Optional) The Be
Page 15 and 16: 3.8 UltraDottie IIII MAINTENANCE AN
Page 17 and 18: 3.2 First steps for use Release the
Page 19 and 20: uttons (see section 3.1). The funct
Page 21 and 22: Screen ruling in (lines/inch) Regul
Page 23 and 24: Screen angle in ° Logarithmic Refl
Page 25 and 26: • Unit displayed (cm or inch) •
Page 27 and 28: on the X axis of the diagram. After
Page 29 and 30: symbol, the measurement must be rep
Page 31 and 32: 33.5.2 Calibration As the UltraDott
Page 33 and 34: transmission mode. This is why no c
Page 35: 3.5.7.3 Dot diameter The diameter o
Page 39 and 40: 3.7 Measuring a plate characteristi
Page 41 and 42: Example: Measuring a plate characte
Page 43 and 44: 3.8 UltraDottie II maintenance and
Page 45 and 46: 4 APPENDIX 35 4.1 TECHNICAL DATA 37
Page 47 and 48: Measurement technique Sensor CMOS 6
Page 49 and 50: 4.2 Serial interface The UltraDotti

Instruction Manual - Beta Industries

Create successful ePaper yourself

Delete template?

Save as template?