Instruction Manual - Beta Industries

More documents

Recommendations

Info

with which the data can be copied into a word processor, a spreadsheet or another software program. The power-saving electronics and LED technology allow up to 30,000 measurements for each set of batteries (2 ordinary commercial AA batteries), which means that no limits are placed on mobility. With the icon-based, graphical user interface <strong>Beta</strong> <strong>Industries</strong> is opening up new paths and offers the user a simple, easy to understand operating concept. 2 7/49
2.2 Safety 2.2.1 Warning For safety reasons it is absolutely necessary to read through the user’s guide and all of the instructions it contains. 2.2.2 General safety tips If the safety recommendations and instructions in this User Guide are not complied with, this can lead to measurement errors or data loss or involve physical injury or damage to property. • UltraDottie II is not intrinsically safe. Therefore the device cannot be used in an environment where there is a risk of explosion. • UltraDottie II may not be used in an area with strong electromagnetic fields. • Use the UltraDottie II in ambient temperatures between 10°C (50°º F) and 40°C (104°F), and do not expose the UltraDottie II to direct sun light. • UltraDottie II should never be opened up. The guarantee expires immediately upon unauthorized opening of the device. Contact your dealer if repairs prove to be necessary. 8/49
Page 1 and 2: UltraDottie II CTP Calibrator Opera
Page 3 and 4: 1 TABLE OF CONTENTS 3 2 GENERAL 5 2
Page 5 and 6: 3.8 UltraDottie IIII MAINTENANCE AN
Page 7: 2 General 2.1 Introduction Dear Bet
Page 11 and 12: 2.3 Packaging and transport Always
Page 13 and 14: 2.5.2 Beta Target (Optional) The Be
Page 15 and 16: 3.8 UltraDottie IIII MAINTENANCE AN
Page 17 and 18: 3.2 First steps for use Release the
Page 19 and 20: uttons (see section 3.1). The funct
Page 21 and 22: Screen ruling in (lines/inch) Regul
Page 23 and 24: Screen angle in ° Logarithmic Refl
Page 25 and 26: • Unit displayed (cm or inch) •
Page 27 and 28: on the X axis of the diagram. After
Page 29 and 30: symbol, the measurement must be rep
Page 31 and 32: 33.5.2 Calibration As the UltraDott
Page 33 and 34: transmission mode. This is why no c
Page 35 and 36: 3.5.7.3 Dot diameter The diameter o
Page 37 and 38: 3.6 Visually checking the dot After
Page 39 and 40: 3.7 Measuring a plate characteristi
Page 41 and 42: Example: Measuring a plate characte
Page 43 and 44: 3.8 UltraDottie II maintenance and
Page 45 and 46: 4 APPENDIX 35 4.1 TECHNICAL DATA 37
Page 47 and 48: Measurement technique Sensor CMOS 6
Page 49 and 50: 4.2 Serial interface The UltraDotti

Instruction Manual - Beta Industries

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?