User Manual

2DFace
The user must select the printer from the list available.
Margins can be set for the design page (these are in
addition to the unprintable area around the edges of the
paper).
A logo, timing contour scale, energy distribution scale and
a comment box can be printed in any of the corners of the
page. The logo is a bitmap file (Printlogo.bmp) in the
Auxfiles folders. This file can be replaced with any bitmap
file.
The comment box can contain any text information to
accompany the printed design, such as the blast name or the
designer's name, scale, etc.
The configuration for a printer can be saved for further use
at a later time. Click the save button , and then enter a
descriptive name for the configuration (Figure 1.23). Click
OK to save the configuration. An existing setup can be
recalled from the list of available configurations on the
Print Design dialog.
Figure 1.23 Save Printer Configuration dialog
JKSimBlast 169