User Manual

2DBench Tutorial
For this example, you can use the default parameters to
drill holes or patterns; however, if you want to change
them, activate the parameters dialog, enter new values and
click [Accept New Values] then [Close].
Select pattern drilling.
Place the cursor on the left side of the screen for the
location of the first hole (row 1, hole 1) and [click].
Set the direction of the front row - move the cursor to
the right. The bearing of the row is shown on the status
bar. [Click] to set the direction.
Set the burden direction by moving the cursor below the
front row line and [click]. The blast pattern is created
on the screen. (The same technique can be used to set
the pattern from the back row – note the [Burden
Direction] in the parameters.)
66 JKSimBlast