8.28 MB - Edge-Core

3
Configuring the Switch
CLI – The following example enables LACP for ports 3 to 6. Just connect these ports
to LACP-enabled trunk ports on another switch to form a trunk.
Console(config)#interface ethernet 1/3 4-105
Console(config-if)#lacp 4-122
Console(config-if)#exit
.
Console(config)#interface ethernet 1/6
Console(config-if)#lacp
Console(config-if)#end
Console#show interfaces status port-channel 1 4-112
Information of Trunk 1
Basic information:
Port type:
100TX
Mac address:
22-22-22-22-22-2d
Configuration:
Name:
Port admin:
Up
Speed-duplex:
Auto
Capabilities:
10half, 10full, 100half, 100full
Flow control status: Disabled
Port security:
Disabled
Max MAC count: 0
Current status:
Created by:
Lacp
Link status:
Up
Port operation status: Up
Operation speed-duplex: 100full
Flow control type: None
Member Ports: Eth1/3, Eth1/4, Eth1/5, Eth1/6,
Console#
3-70