30.06.2015 Views

8.28 MB - Edge-Core

8.28 MB - Edge-Core

8.28 MB - Edge-Core

SHOW MORE
SHOW LESS

Create successful ePaper yourself

Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.

Port Configuration<br />

3<br />

Configuring LACP Parameters<br />

Dynamically Creating a Port Channel –<br />

Ports assigned to a common port channel must meet the following criteria:<br />

• Ports must have the same LACP System Priority.<br />

• Ports must have the same LACP port Admin Key.<br />

• However, if the “port channel” Admin Key is set (page 4-142), then the port Admin<br />

Key must be set to the same value for a port to be allowed to join a channel group.<br />

Note – If the port channel admin key (lacp admin key, page 4-125) is not set (through<br />

the CLI) when a channel group is formed (i.e., it has a null value of 0), this key is set to<br />

the same value as the port admin key used by the interfaces that joined the group (lacp<br />

admin key, as described in this section and on page 4-124).<br />

Command Attributes<br />

Set Port Actor – This menu sets the local side of an aggregate link; i.e., the ports on<br />

this switch.<br />

• Port – Port number. (Range: 1-26)<br />

• System Priority – LACP system priority is used to determine link aggregation<br />

group (LAG) membership, and to identify this device to other switches during LAG<br />

negotiations. (Range: 0-65535; Default: 32768)<br />

- Ports must be configured with the same system priority to join the same LAG.<br />

- System priority is combined with the switch’s MAC address to form the LAG<br />

identifier. This identifier is used to indicate a specific LAG during LACP<br />

negotiations with other systems.<br />

• Admin Key – The LACP administration key must be set to the same value for ports<br />

that belong to the same LAG. (Range: 0-65535; Default: 1)<br />

• Port Priority – If a link goes down, LACP port priority is used to select a backup<br />

link. (Range: 0-65535; Default: 32768)<br />

Set Port Partner – This menu sets the remote side of an aggregate link; i.e., the<br />

ports on the attached device. The command attributes have the same meaning as<br />

those used for the port actor. However, configuring LACP settings for the partner<br />

only applies to its administrative state, not its operational state, and will only take<br />

effect the next time an aggregate link is established with the partner.<br />

3-71

Hooray! Your file is uploaded and ready to be published.

Saved successfully!

Ooh no, something went wrong!