8.28 MB - Edge-Core

4
Command Line Interface
SNMP Commands
Controls access to this switch from management stations using the Simple Network
Management Protocol (SNMP), as well as the error types sent to trap managers.
Table 4-39 SNMP Commands
Command Function Mode Page
snmp-server community Sets up the community access string to permit access to GC 4-100
SNMP commands
snmp-server contact Sets the system contact string GC 4-101
snmp-server location Sets the system location string GC 4-101
snmp-server host Specifies the recipient of an SNMP notification operation GC 4-102
snmp-server enable traps Enables the device to send SNMP traps (i.e., SNMP
GC 4-103
notifications)
show snmp Displays the status of SNMP communications NE, PE 4-103
snmp-server community
This command defines the community access string for the Simple Network
Management Protocol. Use the no form to remove the specified community string.
Syntax
snmp-server community string [ro|rw]
no snmp-server community string
• string - Community string that acts like a password and permits access to
the SNMP protocol. (Maximum length: 32 characters, case sensitive;
Maximum number of strings: 5)
• ro - Specifies read-only access. Authorized management stations are only
able to retrieve MIB objects.
• rw - Specifies read/write access. Authorized management stations are able
to both retrieve and modify MIB objects.
Default Setting
• public - Read-only access. Authorized management stations are only able to
retrieve MIB objects.
• private - Read/write access. Authorized management stations are able to both
retrieve and modify MIB objects.
Command Mode
Global Configuration
Command Usage
The first snmp-server community command you enter enables SNMP. The
no snmp-server community command disables SNMP.
4-100