Acoustica MP3 CD Burner 4. 0 Help

Ripping ProblemsI cannot see a CD tab to rip from!Skips and pops are in my ripped tracks!I cannot see a CD tab to rip from!This is most likely because you do not have an ASPI layer properly installed. Rerunthe installer and reboot.Skips and pops are in my ripped tracks!Older CD drives (readers) do not have the ability to seek properly to a position on aCD and, thus, if they get out of sync, it will produce a pop in the audio. Here aresome things to try.• Make sure the CD is clean and does not have scratches on it. (It may bepermanently damaged and there may be no way to avoid the pop.)• Try turning the "Jitter" setting to "ON" in the Preferences on the "RippingTracks" section. (Ripping may be more accurate, but slower.)• Try ripping the CD on another CD drive if you have more than one.• Shut down other programs, including screensavers and virus checkers to freeup your computer’s resources.• Try ripping to WAV format, instead of MP3, OGG or WMA. (This requires lesscomputer power.)• Change your ASPI layer. (This only applies if you are using the GoldenhawkRip/Burn engine.) If you are using the Acoustica ASPI, try un-checking it touse the default Window’s ASPI layer.• Try purchasing and installing a new CD Drive. (Writers and readers are prettyinexpensive these days.)• Contact our support staff @http://www.acoustica.com/mp3-cd-burner/support.htm