01 Z3 COIL - Enduro Fork Seals

More documents

Recommendations

Info

FIG. 10Fit the bit of a small screwdriver into upperedge slot of the pilot bushing (23) and liftgently. Pull the bushing out of the sliderand make all necessary changes.REPLACING PUMPING ELEMENTSEALSFIG. 11Remove the foot buffer (18) completewith ring (25) from the pumping rod ends(14) and (12).FIG. 12Withdraw the pumping elements (14)and (12) and the rebound spring (15)from the stanchion tube top. Replace theseal ring (13) if damaged or worn out.<strong>Z3</strong> Coil2325 18 12Sx.Dx.131525 18 1414 12
<strong>Z3</strong> CoilFIG. 13 (only right leg)Remove the stop ring (33) from pumpingelement bottom (14) with a small flatscrewdriver.Mark stop ring seat into inner rod forproper fitting.Use the same screwdriver to remove thering (A) and screw inner rod until adjusterthreaded end is disengaged from pumpingelement.Remove inner rod and replace O-ring(27) if damaged.VALVE ASSEMBLY CHANGEFIG. 14To check that the valve assembly is operatingcorrectly, it is necessary to work onthe inside of the stanchion tube.Slip off the stop ring (17) using pointedpliers.Pull the valve assembly (16) out of thetube with one finger in the same sequenceas in the figure.33141727A16
Page 2 and 3: Z3 Coil(100)17580Ø30 +0.050L.MAX=4
Page 4 and 5: INSTRUCTIONSZ3 CoilGENERAL RULES1.
Page 6 and 7: Z3 CoilRECOMMENDATIONS FORMAINTENAN
Page 8 and 9: DISASSEMBLYGENERAL- The reference n
Page 10 and 11: FIG. 4Remove foot nuts (26) and (29
Page 14 and 15: Z3 CoilREASSEMBLYCAUTION: before re
Page 16 and 17: VALVE AND PUMPING RODASSEMBLYFIG. 2
Page 18 and 19: HOW TO FILL WITH OILFIG. 27Pour oil

01 Z3 COIL - Enduro Fork Seals

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?