01 Z3 COIL - Enduro Fork Seals

More documents

Recommendations

Info

HOW TO FILL WITH OILFIG. 27Pour oil little by little when the stanchionsare fully down and then pump with thecrown so as to have a better filling.Ensure proper oil level (H), from the top ofthe stanchion tube, in both legs.SPRING AND CAPFIG. 28Fit the springs (34) into each stanchiontube.FIG. 29Lubricate the O-ring (5) on the cap (4).Turn the preload adjuster (9)counterclockwise until it is at its minimumsetting and install the lower washer (11).Start the caps with the O-ring (5) in placeinto the stanchion tube threads by hand.Tighten caps (4) to 12 Nm.<strong>Z3</strong> Coil3412NmHTravel (mm) H (mm)80 35100 40 Lh.35 Rh.130 5045
SPECIFIC MARZOCCHI TOOLSRef. Item. Description and useA R 5089 AB Slider protector: to remove the oil seal from the sliderB R 5090 Oil seal press: to press oil seal into the slider<strong>Z3</strong> CoilBA
Page 2 and 3: Z3 Coil(100)17580Ø30 +0.050L.MAX=4
Page 4 and 5: INSTRUCTIONSZ3 CoilGENERAL RULES1.
Page 6 and 7: Z3 CoilRECOMMENDATIONS FORMAINTENAN
Page 8 and 9: DISASSEMBLYGENERAL- The reference n
Page 10 and 11: FIG. 4Remove foot nuts (26) and (29
Page 12 and 13: FIG. 10Fit the bit of a small screw
Page 14 and 15: Z3 CoilREASSEMBLYCAUTION: before re
Page 16 and 17: VALVE AND PUMPING RODASSEMBLYFIG. 2

01 Z3 COIL - Enduro Fork Seals

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?