View PDF - Painless Wiring

More documents

Recommendations

Info

6.1.8 You may install your own switch. This switch must connect theOrn/Blk wire to ground ONLY when the car is in PARK. You mayor may not want to use the Blk/Wht wire. The other end of theBlk/Wht wire is already connected to ground through the harness.Note: Not attaching the orn/blk wire to anything may turn on the check enginelight6.1.9 The single purple wire is the wire that powers the lockup functionon the transmission. If you ARE NOT using the lockup then youwill tape off and store this wire. If you ARE using thetransmission lockup function then you will have to install a vehiclespeed sensor and a brake switch as described in Paragraph 4.1.2.6.1.10. If you are using the recommended brake switch then you will wireit according to Figure 6.4. The wire jumped to the back of theswitch in the illustration is the wire that has power on it whether ornot the brake is being applied. If you have installed your ownswitch then it must connect the single purple wire to power ONLYwhen the brakes are NOT being applied. If you are using ahydraulic brake switch see page 33 for proper wiring using a relay.Caution:Failure to wire this switch correctly will result in a dangeroussituation on the vehicle.Figure 6.4 Brake switch12
6.2 SENSOR AND RELAY INSTALLATIONA. Take the wiring that was previously routed to the sensors andconnect it according to Table 6.1Figure 6.5 Neutral Safety Switch13
Page 1 and 2: Wire Harness Installation Instructi
Page 3 and 4: TABLE OF CONTENTSList of Figures.
Page 6 and 7: 3.0 TOOLS NEEDEDIn addition to your
Page 8 and 9: 4.2 You should get to know the part
Page 10 and 11: Figure 4.2 External Coil Distributo
Page 12: • When connecting the plugs to th
Page 15: 6.1.1 Find a suitable location to m
Page 19 and 20: Figure 6.9 Knock SensorFigure 6.10
Page 21 and 22: 7.4 SENSOR AND RELAY INSTALLATIONTh
Page 23 and 24: Figure 7.1 Tuned Port Injection Sys
Page 25 and 26: Figure 7.5 Engine Compartment Overv
Page 27 and 28: 9.0 PRE-ADJUSTMENTS BEFORE STARTING
Page 29 and 30: CODE # CIRCUIT AFFECTED CODE # CIRC
Page 31 and 32: STEP 3 - ATTACHING THE B+ POWER WIR
Page 33 and 34: Diagram 2 Early TPI Emissions29
Page 35 and 36: STEP 5 - CONNECTING THE CHARCOAL CA
Page 37 and 38: Diagram 4 Brake Switch Relay Connec

View PDF - Painless Wiring

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?