EIB-Interface 500 I/510 I - Somfy

EIB-Interface 500 I/510 IInstructions for UseNo. Name Function Description6 move command UP / DOWN A „0“ message commands the drive to move to theupper final position, a „1“ message to the lower finalposition.7 STOP command STOP A message to this object causes the drive to stop.8 disable move command YES / NO If the window parameter „window contact(external/local)“ is set to „external“, all Motor movementscan be stopped through this object. A „1“ commandsthe Motor to automatically move to the disabledposition (upper or lower final position, STOP or no movecommand). Further drive commands are ignored. A „0“re-enables the Motor system.9 safety priority command A „1“ generates a move command to the programmablesafety position (upper or lower final position). The Motorsystem is deactivated until a „0“ re-enables the system.10 move roller shutter move 0-100% The roller shutter can be moved to any position withposition a 1 byte message (0% - 100%).EIB Interface 510 I Parameter Description(Factory settings are in italics)Parameter Settings Description❐ Safetysafety position upper final position The drive moves to the upper final position.lower final position The drive moves to the lower final position.STOPThe drive stops.no move command The drive moves up or down when this command isissued. Any further commands are blocked.receive safety signal static The drive moves to the programmed safety position if anon-cyclic safety message is received.cyclicThe drive moves to the programmed safety position if acyclic safety message is received.safety monitoring cycle 14 Überwachungszeitraum zum Empfang eines zyklischenin 5 seconds [1..63]Sicherheitstelegrammes. Die Überwachungszeit mußgrößer eingestellt werden, als die Zykluszeit des sendendenTeilnehmers.14© by SOMFY Rottenburg