EIB-Interface 500 I/510 I - Somfy

SOMFY Motor ILTInstructions for Use2.2.1 Change of directionShould the roller shutter not move in the desired direction,e. g. upwards after pressing the UP button, press andhold the STOP button for approximately 2 seconds.2.3 Lower final positionadjustment● Set slide switch (A) to the positionfor adjusting the lower finalposition.● Lower roller shutter with theDOWN button (D) to the desiredposition.● When lower final position is reached, release theDOWN button (D).Important:It is possible to correct final position settingsby simply repeating the above procedures.2.4 User setting (intermediate position)2.4.2 Initiating user settingThe user setting can be initiated when the roller shutter isstopped in any position by pressing the STOP button (C).3. Western Connector PinAssignment and AttachmentUP (red)PE (blue)+5 V DC (white)DOWN (yellow)3.1 Control line pin assignment (plan view)Depending on the cable type the conductors may also becolour-coded as follows: black, red, green, yellow.3.2 Attaching western connectorsUse a pair of crimping pliers to strip and shorten a controlThe Motor allows you to program the roller shutter with auser setting. This means that in addition to the upper andlower final positions you have a user-programmable intermediateposition where the roller shutter automaticallystops when you press the STOP button and the drive isnot running.2.4.1 Programming user setting with control boxSet slide switch (A) on the control box to the middle position.Your control box now functions like a standardremote control.Press the DOWN button (D) and the roller shutter travelsto the lower final position and automatically stops.redbluewhiteyellowcolour markingcontrol line cableredbluewhiteyellowPress the UP button (B) and the roller shutter travels tothe upper final position and automatically stops.To stop the roller shutter simply press the STOP button(C).● Stop the roller shutter at the desired user settingposition.● When the roller shutter has fully stopped at that position,press and hold the STOP button (C) for 5seconds.line cable and to attach a western connector.Important:Ensure that the western connectors are mountedinversely to each other. Otherwise the pin assignmentof the connectors will nolonger correspond properly (use colour marking onthe control line for orientation).The user setting has now been saved.5© by SOMFY Rottenburg