Sopwith Camel Manual - Hangar 9

Section 6: Bottom Wing Installation Step 4Slide the wing (and tube) into the fuselage. Carefully pushthe wing tight against the fuselage, and then use a #43drill to drill for the anti-rotation screw through the hole inthe fuselage. Again, use care not to let the drill bit slip anddamage the fuselage or wing. Step 6Slide the remaining wing panel into position. Whileholding it tight against the fuselage, drill the hole for thewing tube and the anti-rotation pin. After threading bothholes, secure the wing using two 4-40 x 1/2" socket headscrews and two #4 washers. Step 5Use a 4-40 tap to thread the hole. Secure the wing to .the fuselage using a 4-40 x 1/2" socket head screw and .a #4 washer.Hint: When removing the bottom wing,remove the three socket head screws that donot have threadlock. Leaving the final screw inplace will save you some time in trying to lineup the hole with the screw in the wing tube.26