Chapter 2 Static Routing

More documents

Recommendations

Info

Examining Serial Interfaces (In the Lab)• Available clock rates, in bits per second, are 1200, 2400,9600, 19200, 38400, 56000, 64000, 72000, 125000, 148000,500000, 800000, 1000000, 1300000, 2000000, and4000000.• If a DTE interface is configured with the clock ratecommand, the IOS disregards it.CCNA2-27 Chapter 2Verifying the Serial Interface ConfigurationCCNA2-28 Chapter 2
Verifying the Serial Interface Configuration• If we use the show ip route command again, we can seethat the serial link has been added to the routing table.CCNA2-29 Chapter 2Verifying the Serial Interface Configuration• Although the clock rate command is two words, IOSspells clockrate as a single word in the runningconfiguration and startup configuration files.CCNA2-30 Chapter 2
Page 1: Chapter 2Static RoutingCCNA2-1 Chap
Page 4 and 5: Examining the ConnectionsSerialFast
Page 6 and 7: Examining the ConnectionsDCEDTE•
Page 8 and 9: Examining Router Interfaces• show
Page 12 and 13: Configuring a Serial InterfaceCAN b
Page 16 and 17: Introduction to Routing and Packet
Page 18 and 19: Verifying Changes to the Routing Ta
Page 20 and 21: Devices on Directly Connected Netwo
Page 22 and 23: Cisco Discovery Protocol (CDP)• B
Page 27 and 28: ip route Command• Simpler Syntax:
Page 29 and 30: Configuring Routes to Two or More N
Page 31 and 32: Routing Table Principles and Static
Page 33 and 34: Verifying Static RoutesCCNA2-65 Cha
Page 37 and 38: Modifying Static Routes• There is
Page 39 and 40: Summary Static Routes• Route Summ
Page 41 and 42: Default Static Routes• A default

Chapter 2 Static Routing

Create successful ePaper yourself

Delete template?

Save as template?