Chapter 2 Static Routing

More documents

Recommendations

Info

Examining the ConnectionsDCEDTE• Serial Connectors:• In the lab, , the serial line is connected back-toto-back.• The router that has the DCE cable connected providesthe clock rate (bandwidth) by defining the specific clockrate to be used on the connection.CCNA2-11 Chapter 2Examining the Connections• Ethernet Connectors: Standard RJ45 UTP cables.• Switch-toto-Router• Hub-toto-Router• Switch-toto-PC/Server• Hub-toto-PC/Server• Switch-toto-Switch• PC/Server-toto-PC/Server• Switch-toto-Hub• Hub-toto-Hub• Router-toto-Router• Router-toto-PC/ServerCCNA2-12 Chapter 2
Examining the Connections• Console Connection: PC COM1 port using HyperTerminalCCNA2-13 Chapter 2Introduction to Routing and Packet ForwardingRouter Configuration ReviewCCNA2-14 Chapter 2
Page 1: Chapter 2Static RoutingCCNA2-1 Chap
Page 4 and 5: Examining the ConnectionsSerialFast
Page 8 and 9: Examining Router Interfaces• show
Page 12 and 13: Configuring a Serial InterfaceCAN b
Page 14 and 15: Examining Serial Interfaces (In the
Page 16 and 17: Introduction to Routing and Packet
Page 18 and 19: Verifying Changes to the Routing Ta
Page 20 and 21: Devices on Directly Connected Netwo
Page 22 and 23: Cisco Discovery Protocol (CDP)• B
Page 27 and 28: ip route Command• Simpler Syntax:
Page 29 and 30: Configuring Routes to Two or More N
Page 31 and 32: Routing Table Principles and Static
Page 33 and 34: Verifying Static RoutesCCNA2-65 Cha
Page 37 and 38: Modifying Static Routes• There is
Page 39 and 40: Summary Static Routes• Route Summ
Page 41 and 42: Default Static Routes• A default

Chapter 2 Static Routing

Create successful ePaper yourself

Delete template?

Save as template?