Chapter 2 Static Routing

More documents

Recommendations

Info

Introduction to Routing and Packet ForwardingExploring DirectlyConnected NetworksCCNA2-31 Chapter 2Verifying Changes to the Routing Table• Routing Table Concepts:• The routing table consists of a list of “known” networkaddresses.• Those addresses that are directly connected,configured statically and/or learned dynamically.CCNA2-32 Chapter 2
Verifying Changes to the Routing Table• Observing Routes as They Are Added:• The debug ip routing command will display anychanges that the router performs when adding orremoving routes from the routing table.• After no shutdown the interface is up and up• The network is added to the routing table.CCNA2-33 Chapter 2Verifying Changes to the Routing Table• Changing an IP Address:• Disable the interface with the shutdown command.• Remove the current IP Address with theno ip address command.• The route is removed from the routing table.• Add the new IP address and enable the interface.CCNA2-34 Chapter 2
Page 1: Chapter 2Static RoutingCCNA2-1 Chap
Page 4 and 5: Examining the ConnectionsSerialFast
Page 6 and 7: Examining the ConnectionsDCEDTE•
Page 8 and 9: Examining Router Interfaces• show
Page 12 and 13: Configuring a Serial InterfaceCAN b
Page 14 and 15: Examining Serial Interfaces (In the
Page 18 and 19: Verifying Changes to the Routing Ta
Page 20 and 21: Devices on Directly Connected Netwo
Page 22 and 23: Cisco Discovery Protocol (CDP)• B
Page 25 and 26: Introduction to Routing and Packet
Page 27 and 28: ip route Command• Simpler Syntax:
Page 29 and 30: Configuring Routes to Two or More N
Page 31 and 32: Routing Table Principles and Static
Page 33 and 34: Verifying Static RoutesCCNA2-65 Cha
Page 35 and 36: Introduction to Routing and Packet
Page 37 and 38: Modifying Static Routes• There is
Page 39 and 40: Summary Static Routes• Route Summ
Page 41 and 42: Default Static Routes• A default

Chapter 2 Static Routing

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?