Chapter 2 Static Routing

More documents

Recommendations

Info

Exit Interface is DownBEFOREAFTER• Cannot have a route if the exit interface does not exist.• If an interface is manually taken down (shutdown) or a linkfails, all routes that are resolved to that interface as the exitinterface will be removed from the routing table.CCNA2-67 Chapter 2Exit Interface is DownREINSTATED• If the interface is manually activated (no shutdown) or thelink is restored, the static routes will be reinstated in therouting table.• The ip route commands still exist in the runningconfiguration file.CCNA2-68 Chapter 2
Introduction to Routing and Packet ForwardingStatic Routes withExit InterfacesCCNA2-69 Chapter 2Configuring a Static Route with an Exit Interface• An alternative way of configuring static routes is to specifythe exit interface instead of the next-hop address.CCNA2-70 Chapter 2
Page 1: Chapter 2Static RoutingCCNA2-1 Chap
Page 4 and 5: Examining the ConnectionsSerialFast
Page 6 and 7: Examining the ConnectionsDCEDTE•
Page 8 and 9: Examining Router Interfaces• show
Page 12 and 13: Configuring a Serial InterfaceCAN b
Page 14 and 15: Examining Serial Interfaces (In the
Page 16 and 17: Introduction to Routing and Packet
Page 18 and 19: Verifying Changes to the Routing Ta
Page 20 and 21: Devices on Directly Connected Netwo
Page 22 and 23: Cisco Discovery Protocol (CDP)• B
Page 25 and 26: Introduction to Routing and Packet
Page 27 and 28: ip route Command• Simpler Syntax:
Page 29 and 30: Configuring Routes to Two or More N
Page 31 and 32: Routing Table Principles and Static
Page 33: Verifying Static RoutesCCNA2-65 Cha
Page 37 and 38: Modifying Static Routes• There is
Page 39 and 40: Summary Static Routes• Route Summ
Page 41 and 42: Default Static Routes• A default

Chapter 2 Static Routing

Create successful ePaper yourself

Delete template?

Save as template?