Chapter 2 Static Routing

More documents

Recommendations

Info

Cisco Discovery Protocol (CDP)• By default, each Ciscodevice sends periodicmessages to directlyconnected Ciscodevices.• These messages areknown as CDPadvertisements.• Information gatheredfrom other devicescan assist you:• in making network design decisions, troubleshooting,making changes and network discovery.CCNA2-43 Chapter 2Cisco Discovery Protocol (CDP)R1 and R2areneighbours.R2 and R3areneighbours.R1 and R3 are NOT neighbours.• Layer 3 Neighbours:• At Layer 3, routing protocols consider neighbors to bedevices that share the same network address space.CCNA2-44 Chapter 2
Cisco Discovery Protocol (CDP)• Layer 2 Neighbours:• CDP operates at Layer 2 only.• CDP neighbours are Cisco devices that share the samephysical data connection.CCNA2-45 Chapter 2Cisco Discovery Protocol (CDP)• CDP Operation (show(cdp neighbors):• Device ID: The configured host name of the device.• Port identifiers: The name of the local and remote portsthat share the physical connection.• Capability: The type of device.• Platform: The hardware platform of the device.CCNA2-46 Chapter 2
Page 1: Chapter 2Static RoutingCCNA2-1 Chap
Page 4 and 5: Examining the ConnectionsSerialFast
Page 6 and 7: Examining the ConnectionsDCEDTE•
Page 8 and 9: Examining Router Interfaces• show
Page 12 and 13: Configuring a Serial InterfaceCAN b
Page 14 and 15: Examining Serial Interfaces (In the
Page 16 and 17: Introduction to Routing and Packet
Page 18 and 19: Verifying Changes to the Routing Ta
Page 20 and 21: Devices on Directly Connected Netwo
Page 27 and 28: ip route Command• Simpler Syntax:
Page 29 and 30: Configuring Routes to Two or More N
Page 31 and 32: Routing Table Principles and Static
Page 33 and 34: Verifying Static RoutesCCNA2-65 Cha
Page 37 and 38: Modifying Static Routes• There is
Page 39 and 40: Summary Static Routes• Route Summ
Page 41 and 42: Default Static Routes• A default

Chapter 2 Static Routing

Create successful ePaper yourself

Delete template?

Save as template?