Chapter 2 Static Routing

More documents

Recommendations

Info

Introduction to Routing and Packet ForwardingStatic Routes with“Next Hop” AddressesCCNA2-49 Chapter 2Purpose and Command Syntax (ip(route)Stub Network:A network accessedby a single route.Running a dynamicrouting protocolbetween R1 and R2 isa waste of resources.• Static routes are commonly used when routing froma stub network.CCNA2-50 Chapter 2
Page 1: Chapter 2Static RoutingCCNA2-1 Chap
Page 4 and 5: Examining the ConnectionsSerialFast
Page 6 and 7: Examining the ConnectionsDCEDTE•
Page 8 and 9: Examining Router Interfaces• show
Page 12 and 13: Configuring a Serial InterfaceCAN b
Page 14 and 15: Examining Serial Interfaces (In the
Page 16 and 17: Introduction to Routing and Packet
Page 18 and 19: Verifying Changes to the Routing Ta
Page 20 and 21: Devices on Directly Connected Netwo
Page 22 and 23: Cisco Discovery Protocol (CDP)• B
Page 26 and 27: ip route Command• Complete Syntax
Page 28 and 29: Configuring Static Routes172.16.2.2
Page 30 and 31: Configuring Routes to Two or More N
Page 32 and 33: Routing Table Principles and Static
Page 34 and 35: Exit Interface is DownBEFOREAFTER
Page 36 and 37: Configuring a Static Route with an
Page 38 and 39: Static Routes with Ethernet Interfa
Page 40 and 41: Summary Static RoutesCCNA2-79 Chapt
Page 42: Default Static Routes• A common u

Chapter 2 Static Routing

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?