Chapter 2 Static Routing

More documents

Recommendations

Info

Verifying Changes to the Routing Table• Important notes on the debug command:• The debug commands, especially the debug all command,should be used sparingly.• Useful when configuring or troubleshooting a network.• Can disrupt router operations.• Intensive use of CPU and memory resources.• Run as few debug processes as necessary.• Disable them immediately when they are no longerneeded.CCNA2-35 Chapter 2Devices on Directly Connected NetworksAre all interfaces up and up?CCNA2-36 Chapter 2
Devices on Directly Connected NetworksAre all directly connected networks in the routing tables?CCNA2-37 Chapter 2Devices on Directly Connected Networks• When a router only has its interfaces configured, and therouting table contains the directly connected networks but noother routes, only devices on those directly connectednetworks are reachable.CCNA2-38 Chapter 2
Page 1: Chapter 2Static RoutingCCNA2-1 Chap
Page 4 and 5: Examining the ConnectionsSerialFast
Page 6 and 7: Examining the ConnectionsDCEDTE•
Page 8 and 9: Examining Router Interfaces• show
Page 12 and 13: Configuring a Serial InterfaceCAN b
Page 14 and 15: Examining Serial Interfaces (In the
Page 16 and 17: Introduction to Routing and Packet
Page 20 and 21: Devices on Directly Connected Netwo
Page 22 and 23: Cisco Discovery Protocol (CDP)• B
Page 27 and 28: ip route Command• Simpler Syntax:
Page 29 and 30: Configuring Routes to Two or More N
Page 31 and 32: Routing Table Principles and Static
Page 33 and 34: Verifying Static RoutesCCNA2-65 Cha
Page 37 and 38: Modifying Static Routes• There is
Page 39 and 40: Summary Static Routes• Route Summ
Page 41 and 42: Default Static Routes• A default

Chapter 2 Static Routing

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?