Chapter 2 Static Routing

More documents

Recommendations

Info

Devices on Directly Connected Networks? X?X• When a router only has its interfaces configured, and therouting table contains the directly connected networks but noother routes, only devices on those directly connectednetworks are reachable.CCNA2-39 Chapter 2Devices on Directly Connected Networks• Remote networks are unreachable.CCNA2-40 Chapter 2
Devices on Directly Connected Networks• The IOS routing table process checks to see whether the24 leftmost bits (subnet mask) of a packet’s s destination IPaddress (172.16.3.1) match the entries in the routing table.• If so, , the packet is switched to that interface.• If not, , the packet is dropped.CCNA2-41 Chapter 2Cisco Discovery Protocol (CDP)• CDP is a powerfulnetwork-monitoringand troubleshootingtool.• Cisco proprietary.• Enables you to accessa summary of protocoland addressinformation.• Directly connectedCisco devices only.CCNA2-42 Chapter 2
Page 1: Chapter 2Static RoutingCCNA2-1 Chap
Page 4 and 5: Examining the ConnectionsSerialFast
Page 6 and 7: Examining the ConnectionsDCEDTE•
Page 8 and 9: Examining Router Interfaces• show
Page 12 and 13: Configuring a Serial InterfaceCAN b
Page 14 and 15: Examining Serial Interfaces (In the
Page 16 and 17: Introduction to Routing and Packet
Page 18 and 19: Verifying Changes to the Routing Ta
Page 22 and 23: Cisco Discovery Protocol (CDP)• B
Page 27 and 28: ip route Command• Simpler Syntax:
Page 29 and 30: Configuring Routes to Two or More N
Page 31 and 32: Routing Table Principles and Static
Page 33 and 34: Verifying Static RoutesCCNA2-65 Cha
Page 37 and 38: Modifying Static Routes• There is
Page 39 and 40: Summary Static Routes• Route Summ
Page 41 and 42: Default Static Routes• A default

Chapter 2 Static Routing

Create successful ePaper yourself

Delete template?

Save as template?