TurboCAD V12.3 Pro - Timber Frame Barn - Textual Creations

More documents

Recommendations

Info

Press Esc to deselect the selection.Switch to Isometric SE view.Turn off all the layers except layer 0.Select the six right knee braces and the six upper knee braces.Tab into the Inspector Bar and enter 3 in the Delta X field. Press Enter to move them so they are flushwith the out side of the posts.Create a new layer caller Knee Braces.101
Doors / Door MaterialsSelect the Door tool from the Architecture toolbar.Right mouse click on the Door tool icon to open the <strong>Pro</strong>perties dialogue.Under the Door Main tab adjust the various settings to reflect those in the image below.Under the Door Dimension tab adjust the various settings to reflect those in the image below.129
Page 1 and 2: TurboCAD V12.3 Pro - Timber Frame B
Page 3: Table of Contents__________Table of
Page 6 and 7: The Hermes Barn - Main TimbersImage
Page 8 and 9: Sometimes it is best to set the Spa
Page 10 and 11: Materials Application - Session 1A
Page 12 and 13: Press Esc to exit the Rubber Stamp
Page 14 and 15: This embeds the image into the draw
Page 16 and 17: Open the Blocks palette.Left mouse
Page 18 and 19: Press and hold the Shift key down.
Page 22 and 23: Under the Door Materials tab ensure
Page 24 and 25: ShinglesThin boxes will now be plac
Page 26 and 27: Left mouse click the yellow folder
Page 28 and 29: Press the Space Bar to exit the too
Page 30: Once just inside, select the Slide

TurboCAD V12.3 Pro - Timber Frame Barn - Textual Creations

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?