Modification Cardigan - My Label 3D Fashion Pattern Software

Print out pattern piecesPosition, save and print out pattern pieces.For the cardigan, only the front and back section, sleeve and front facing are necessary.The remaining pattern pieces can be placed on the half of the back section not requiredin order to minimise paper consumption.‘Work table’Print previewCollarThe original Barn Jacket collar is not particularly suited to the Cardigan, so the ‘MilitaryJacket’ collar is used.The collar can be printed out separately in DIN A4.In the Style Drawer, under the ‘Jackets’ tab, select the 'Military Jacket'.o In the same model, open ‘Military Jacket’o Increase base of neck in the Style Properties to 47cm.o Position collar so as to save space and print out separately (‘Print Selection’).Cut out pattern pieces and make alterations by hand Tip: If you are constructing the Cardigan with an overlocker, the seam allowance onall pattern pieces can be reduced to 1 cm.After printing out the pieces, check all new cutting and marking lines and correct them ifnecessary.