FHA-C Series - Harmonic Drive LLC

More documents

Recommendations

Info

Chapter 4 Options4-7-2 Adjusting procedures for sensor locationsThe adjusting procedures are presented as follows:1. Loosen each two screws fixing a disk with an origin slit and dogs for limit switch 1 and 2 respectively as easilyas turning the dogs by hand.2. Adjust the clockwise actuating position turning the dog for the limit switch 2, and fix it with the two loosened screws.3. Adjust the counter-clockwise actuating position turning the dog for the limit switch 1, and fix it with the two loosened screws.4. Turn the actuator at low speed while the origin sensor is active, and find the best position for the origin monitoringthe output of the origin sensor. After finding the origin position, fix the disk with the two loosened screws.Note 1: The screws for the disk and the dogs are fixed temporarily. Fix them tightly after adjusting above.Note 2: Fixing measure against looseness is recommended after fixing the screws.Note 3: Confirm generation of sensor signals at proper actuator position during test run after the adjusting.Fixing screws for limit switch 2:2-M3Fixing screws for limit switch 1:2-M3Limit switch 2Limit switch 1Origin sensor Fixing screws for origin disk: 2-M3Origin diskFixing range of screws for origin diskFixing range of screws for limit switchDog for limit switch 1 Dog for limit switch 239
Chapter 4 Options4-7-3 Movable range for each limit switchThe mechanical limit switches have limits for the movable range of the actuator as follows:Movable range for limit switch 1 Moveable range for limit switch 2Moveable rangeActuating positionActuating positionMovable range for limit switch 1 Moveable range for limit switch 2Moveable rangeActuating positionActuating positionMoveable range!CAUTIONDo not overrun beyond the moveable range mentioned above.The over running may damage the limit switch resulting mechanical failure and physical injury.Harmonic Drive LLC 800-921-333240
Page 2: FHA-C series
Page 6 and 7: Chapter 1 Overview of the FHA-C ser
Page 16: Chapter 1 Overview of the FHA-C ser
Page 22: Chapter 2 Guidelines for sizingChap
Page 25 and 26: Chapter 2 Guidelines for sizing•
Page 27 and 28: Chapter 2 Guidelines for sizing2-4
Page 29 and 30: Chapter 2 Guidelines for sizing2-4-
Page 31 and 32: Chapter 2 Guidelines for sizingAllo
Page 34 and 35: Chapter 3 Installing the FHA actuat
Page 36 and 37: Chapter 3 Installing the FHA actuat
Page 38 and 39: Chapter 4 Options4-2 Brake for moto
Page 40 and 41: Chapter 4 Options4-5 5 meter cables
Page 44 and 45: Chapter 4 Options4-8 Extension cabl
Page 46 and 47: Appendix 1 Unit conversion(7) Angul
Page 49 and 50: Moment of inertia2 Inertia of cylin
Page 51: Harmonic Drive LLCBoston247 Lynnfie

FHA-C Series - Harmonic Drive LLC

Create successful ePaper yourself

Delete template?

Save as template?