bentrup TC507 - Toma

seg#oprog#kvaluetmptimermpdwellh.min°C°C/h°F°F/hThe TC507 is the first controller on the market whichprovides you with the very handy feature of entering aramp as degrees centrigrade per hour or as time to atemperature. In the current example you can entersegment 1 as 2 hours instead of 250°C/h. To do this,press key „time“ instead of „rmp“ and enter the timeof 2.00 hours.To double check you can press the key „rmp“ and youwill find the value of „250°C/h“ as you expect. Thiscalculation works in either direction.When entering an uncontrolled ramp (SKIP) in timemode you have to enter „0“ (see our example).ProgrammesDepending on programme length and some otherparameters the TC507 is capable of saving up to 99firing curves as programmes. Once a firing curve hasbeen saved as a programme it can be called up easilyto be modified, saved again or simply used by startingthe firing.memo3endSaving Programmesseg#okprog# blinkingseg#valuetmptimevaluermpdwellh.min°C°C/h°F°F/hh.min°C°C/h°F°F/hTo save a firing curve that has been entered before ase.g. programme number 35 proceed with the followingsteps: Press key (8). The display (6) is blinking askingyou to enter the programme number (the decimalpoint means that a programme is to be saved).Now enter programme number 35 using the digitkeys. Display (6) reads the programme number. Theprogramme number is only shown if the current firingcurve is identical with the saved programme (which isalways the case after loading or saving a programme).Therefore if you change any value of the current firingcurve the display (6) becomes blank until you savethis programme.5 o ktmpNoteThe progamme number must always be entered as a 2prog#time rmp dwelldigit number. Example: Enter „05“ for programme no. 57