bentrup TC507 - Toma

When starting the programme as described in theexample the TC507 starts at 1 hour 55 minutes (not 2hours as programmed) since the firing begins at theactual kiln temperature of 25°C (and not 0°C)Display of Setpointand remaining Timeseg#oprog#kvaluetmptimermpdwellh.min°C°C/h°F°F/hPressing the key (10) followed by key (20) changes thedisplay (13) to the setpoint temperature. Viewing thesetpoint allows you to check whether there is atechnical problem with the kiln or an error in enteringthe programme. An actual temperature near thesetpoint always confirms proper kiln operation.During ramps you can check the setpoint counting up(or down) continuously. During a dwell the setpointsstays at the programmed temperature.Pressing the key (10) followed by key (20) againswitches the display (13) back to the remaining time inthe segment.Every 15 seconds the display (13) flashes themaximum temperature of the currently processedfiring. You can disable this feature in the configurationif you prefer.Checking the CurrentProgrammeAlso during a running programme you can - as onentering the programme - call up all programmevalues using the keys (4), (5), (14), (16) and (17). If youwant to change a value you must stop the firing first(press key (19) once).When restarting a programme after having changed avalue, in general it is continued exactly at the pointwhere it has been interrupted. If you change asegment which already has been processed the TC507starts the programme from the beginning.Same applies if you totally reload a programme (forinstance by calling up a programme pressing key (7)etc. ).9