Download the manuel - Drolet

OPERATING THE STOVE USING A THERMOSTATA thermostat may help you maintain a constant house temperatureautomatically. A low voltage thermostat or 24 Volt thermostat is required. Afixed wall mount or hand held model can be used. The control panel can beset up two ways to operate your stove in thermostatic mode.THERMOSTAT INSTALLATIONUnplug the stove from the power outlet.Connect two thermostat wires to the terminal block located on thelower right side of the back of the stove. To do so, loosen the twoscrews and insert the wires in the terminals. Tighten the two screws.(See Figure 15)If you are using a wireless wall thermostat or a hand held thermostaticremote control, you can locate the receiver behind the stove’s backpanel, on the right end side, just below the terminal block. Mostreceivers are already equipped with quick-connect terminals. Simplyunplug the PC board wires connected to the back of the terminal blockand connect them directly with the receiver’s terminals. Location ofthe thermostat is very important to obtain the best comfort andefficiency from you ECO-35. The thermostat should be mounted 50inch from the floor on a wall located 15 to 20 feet from the stove. Youshould avoid an installation directly in front of the stove to avoidcycling.(See Figure 16)MODESTHERMOSTATWIRE TERMINALFigure 15Thermostat terminalTHERMOSTATIC MODETo use this mode, the thermostat button must be pushedupon starting the stove. The heat setting is then selected using the“Heat Level” selector. When set in thermostatic mode, the stove willautomatically run at the heat level selected until the set roomtemperature is reached. When that occurs, the stove will switch toheat setting #1 (lowest) until the thermostat calls for heat again. Theconvection blowers will also slow to its lowest speed. When thethermostat calls for heat again, the stove will increase its feed rate tomatch the heat setting selected.N.B.: If the room temperature remains stable and the thermostatdoes not call for heat during at least 45 minutes, the stove will shutdown. When the thermostat calls for heat again, the stove will start anignition cycle. Once the ignition cycle is completed, the stove willincrease its feed rate to match the heat setting selected.16