Download the manuel - Drolet

More documents

Recommendations

Info

OPERATING THE STOVE USING A THERMOSTATA thermostat may help you maintain a constant house temperatureautomatically. A low voltage thermostat or 24 Volt thermostat is required. Afixed wall mount or hand held model can be used. The control panel can beset up two ways to operate your stove in thermostatic mode.THERMOSTAT INSTALLATIONUnplug the stove from the power outlet.Connect two thermostat wires to the terminal block located on thelower right side of the back of the stove. To do so, loosen the twoscrews and insert the wires in the terminals. Tighten the two screws.(See Figure 15)If you are using a wireless wall thermostat or a hand held thermostaticremote control, you can locate the receiver behind the stove’s backpanel, on the right end side, just below the terminal block. Mostreceivers are already equipped with quick-connect terminals. Simplyunplug the PC board wires connected to the back of the terminal blockand connect them directly with the receiver’s terminals. Location ofthe thermostat is very important to obtain the best comfort andefficiency from you ECO-35. The thermostat should be mounted 50inch from the floor on a wall located 15 to 20 feet from the stove. Youshould avoid an installation directly in front of the stove to avoidcycling.(See Figure 16)MODESTHERMOSTATWIRE TERMINALFigure 15Thermostat terminalTHERMOSTATIC MODETo use this mode, the thermostat button must be pushedupon starting the stove. The heat setting is then selected using the“Heat Level” selector. When set in thermostatic mode, the stove willautomatically run at the heat level selected until the set roomtemperature is reached. When that occurs, the stove will switch toheat setting #1 (lowest) until the thermostat calls for heat again. Theconvection blowers will also slow to its lowest speed. When thethermostat calls for heat again, the stove will increase its feed rate tomatch the heat setting selected.N.B.: If the room temperature remains stable and the thermostatdoes not call for heat during at least 45 minutes, the stove will shutdown. When the thermostat calls for heat again, the stove will start anignition cycle. Once the ignition cycle is completed, the stove willincrease its feed rate to match the heat setting selected.16
N.B.: It is possible to change the setting of your unit such that if thethermostat does not call for heat after 45 minutes, the unit will remainat the lowest heat setting (#1) but will not shut down (this is the PILOTON mode). The stove will remain at the lowest heat level until thethermostat calls for heat again. If you prefer that your unit runsfollowing that logic, you need to change the setting to PILOT ON bythe pressing the following two buttons on the PC Board:First press , hold it, and then press . Hold the twobuttons for a couple of seconds.Once you do that, the letters P, I, L, O, T, O, N will appear on the PCBoard to let you know that you are in the “PILOT ON” mode. If youwish to go back to the default thermostatic mode (i.e. the unit shutsdown after 45 minutes if the thermostat does not call for heat), simplypress the same two buttons again for a couple of seconds. Theletters P, I, L, O, T, A, U, T, O will appear on the PC Board to let youknow that you are in the “PILOT AUTO” mode.SHOULD BE AVOIDEDNOTE: When in thermostatic mode:You should not operate the manual control or play with thetemperature setting.YOUR THERMOSTAT SHOULD BE INSTALLED BY ANAUTHORIZED DEALER OR SERVICE PERSON.D = MINIMUM DISTANCE 15 FEETFigure 16Thermostat location17
Page 1 and 2: MODEL ECO-35FREESTANDINGOWNER’S M
Page 3 and 4: SAFETY PRECAUTIONSDo not operate yo
Page 5 and 6: RECOMMENDED MAINTENANCE SCHEDULE ..
Page 7 and 8: COMBUSTION AIR SUPPLYFor a mobile h
Page 9 and 10: EQUIVALENT VENT LENGHT (EVL)The lon
Page 11: VERTICALLY INTO EXISTING MASONRY FI
Page 14 and 15: COMBEX tmYour stove uses a unique p
Page 18 and 19: OPERATING SAFETY PRECAUTIONSPLEASE
Page 20 and 21: VACCUM USEIf a vacuum is used to cl
Page 22 and 23: RECOMMENDED MAINTENANCE SCHEDULEUse
Page 24 and 25: STOVE SHUTS OFF AND DISPLAYS WARNIN
Page 26 and 27: STOVE STOPS FEEDING PELLETS AND SHO
Page 28 and 29: MESSAGEWARNING CODESCORRESPONDING W
Page 30 and 31: REPLACEMENT PARTSContact an Authori
Page 32 and 33: INSPECTION AND REPAIR FORMAPPENDIX

Download the manuel - Drolet

Create successful ePaper yourself

Delete template?

Save as template?