CF2000 Instruction Manual - Illumination Technologies

More documents

Recommendations

Info

Technical Data7.3 Color FiltersThere are standard filters offered for use in the CF2000. Below is a partial list of highefficiency filter that are offered to go into the light source. These filters a come installedin a spacer ring for ease of handling and to increase durability. The nominal cutoff isplus or min 5nm. See Accessories and Service Part for part numbers. Spacer ringsare also available for use with customer chosen filters. Ring are available for 20 mmdiameter filters with a thickness range of 2 to 6mm.ColorRed FilterGreen FilterOrange FilterYellow FilterBlue FilterBlue -Green FilterDay Light FilterSpectral Rangel> 610nm500nm580nml>520nml
CF2000 SeriesService and TroubleshootingRoutine service:The only routine service the at this unit requires is changing the lamp and keeping the interior ofthe unit clean and free of dust and debris. A periodic cleaning of the unit using pressurized air toremove accumulated interior debris should be sufficient. Special attention such be given to thephotosensor located on the lamp bracket. It may be cleaned with a glass cleaner to ensure theproper operation of the Light-Lock technology. See below for photosensor locationTroubleshooting:Basic troubleshooting of the unit should be done following the chart below.* If the solutions donot resolve the problem please contact the factory.Symptom Causes SolutionsLack of light1. The unit has blown its powerfuses ( If the fan is still running thefuses are good)2. Lamp is burned out or damaged3. Lamp is not seated into socket4. Lamp cord or connector isdamaged1. Replace the power fuses2. Replace lamp and Calibrate3. Inspect socket for damage and reseatlamp4. If the cord is brown or broken contactthe factoryLack of light and no fanoperationUnit will not calibrate –Red Light on 4910Will not respond to remotecommandsCan't control intensity1. No power to unit2. Blown power fuses1. Lamp does not meet operationspecifications1. Set switches not set correct2. Damaged external cable1. Unit is not calibrated1. Check power cord is completelyinserted2. Check for damage to power cord andreplace as needed3. Replace fuses1. Replace lamp and Calibrate1. Set switches to remote communicationsection settings2. Check cables for breaks (Use “HEL”command to check)1. Calibrate unit2. Photosensor is dirty3. Lamp is bad2. Clean per above3. Replace lamp and calibrate unit18Copyright 2005 ITPN 850-CF2000Illumination Technologies Inc. Rev 3
Page 2 and 3: Illlumination TechnologiesIndexCont
Page 4 and 5: LAMPOUTCALIBRATIONCONNECTORCF2000 S
Page 6 and 7: LAMPOUTWHEELHOMEMounting and Cleara
Page 8 and 9: OperationsOperating Position Front
Page 10 and 11: OperationsThe communications board
Page 12 and 13: OperationsThe unit can be set to ru
Page 14 and 15: CalibrationCF2000 SeriesCalibration
Page 16 and 17: Technical DataCF2000 Series7.1 Ligh
Page 20 and 21: Service and TroubleshootingSymptom
Page 22 and 23: CF2000 SeriesSpare Parts/Accessorie
Page 24: AppendixCF2000 SeriesAPPENDIX AA) C
Page 28 and 29: AppendixB.2) SAMPLE PROGRAMSCommand
Page 30 and 31: AppendixMyString = MyString & MyCha

CF2000 Instruction Manual - Illumination Technologies

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?