C10- PARALLEL PORT INTERFACE CARD Rev. 10 - CNC4PC

More documents

Recommendations

Info

C10 (Rev. 10) User Manual4. Board description4.1 Using configuration jumper.4.1.1 Using the COM configuration jumper.There is a jumper (X7) that allows youto select +5VDC or GND for the COMpins.1-2: COM= GND2-3: COM= +5VDCRevision: 01/27/2010 http://cnc4pc.com/TechDocs/C10R10_User_Manual.pdf 4/18
C10 (Rev. 10) User Manual4.1.2 Using the Pins 2-9 direction jumper.There is a jumper (X6) to selectthe pins 2-9 direction.1-2: OUTPUTS2-3: INPUTS4.1.3 Using the Pull-up or Pull-down selection jumper for pins 2-9.Jumper (X4) allows change the inputconfiguration for pins 2-9. Using the Pullupor Pull-down selection jumpers for pins2-9 the input voltage is pulled through a4.7Kohm resistor to up or down in thisway:1-2: PULL-DOWN2-3: PULL-UPRevision: 01/27/2010 http://cnc4pc.com/TechDocs/C10R10_User_Manual.pdf 5/18
Page 3: C10 (Rev. 10) User Manual3. Specifi
Page 7 and 8: C10 (Rev. 10) User Manual5. Connect
Page 9 and 10: C10 (Rev. 10) User Manual6.3 Dedica
Page 11 and 12: C10 (Rev. 10) User ManualFig. 4 Wir
Page 13 and 14: C10 (Rev. 10) User ManualCalculatin
Page 15 and 16: C10 (Rev. 10) User Manual7.4 Other
Page 17 and 18: C10 (Rev. 10) User ManualSYMPTOM 2:

C10- PARALLEL PORT INTERFACE CARD Rev. 10 - CNC4PC

Create successful ePaper yourself

Delete template?

Save as template?