Sony RealShot Manager Quick Set Up Guide

More documents

Recommendations

Info

Configuring Camera Network SettingsFor quick setup of cameras, use the IP Setup Program Supplied with the camera, this will find allcameras on a local network and allow you to configure their IP addresses. Alternatively, refer to theinstallation section of the Operation Manual for the product.Using the IP Setup ProgramWith the physical network connections complete and the PC and cameras powered up, run the IPSetup Program. The program probes the network to find connected cameras, and then reportsthem in the list at the top of the page. Highlight the camera you want to set up and enter the newnetwork settings in the boxes below. You must also enter the administrator user name andpassword for the camera, then click on OK, at the bottom right of the page. The change takes afew seconds to be updated, if the camera does not appear to update after a minute, use the rebootbutton to force the camera to restart, and if necessary enter the values again.Note: The IP Setup Program can generate a lot of network traffic and should be used only duringinstallation and setting up. It should only be used on closed networks.© Sony PSE 2004This document is intended for use as a guide only. Information in this document is subject to change without notice.6
Network InfrastructureAs well as bandwidth requirements, you also need to know the physical limits of the network.The 100BaseTX standard uses twisted-pair cable known as CAT5 or CAT5E, the maximum cablelength between devices is 100 metres. A hub, switch or repeater can be used to extend the cable.For longer distances of up to 2000 metres, a 100BaseFX multi-mode fibre optic cable can be used.A converter is required to interface with the camera. For distances over 2000m, single mode fibrecan be used, alternatively linking to an existing network or using public networks such as ISDN,DSL or the Internet may be more cost effective.Network Settings Example:Installing 16 cameras, and 2 RSM PCs with a remote storage device or NAS.Camera 1 - 192.168.0.101- - - - - - - - - - - - -Camera 16 – 192.168.0.116RSM PC 1 - 192.168.0.10RSM PC 2 - 192.168.0.11NAS device - 192.168.0.50192.168.0.101Ethernet Switch192.168.0.103192.168.0.102192.168.0.11192.168.0.104Network Storage192.168.0.50192.168.0.10RealShot Manager PCClient PC© Sony PSE 2004This document is intended for use as a guide only. Information in this document is subject to change without notice.7
Page 1 and 2: Sony RealShot ManagerQuick Set up G
Page 3 and 4: 7. Select the destination drive and
Page 5: Configuring Windows Network Propert
Page 9: 6. Repeat the procedure for each ca
Page 12 and 13: Storage LocationsBy default, record
Page 14 and 15: Housekeeping and System Management.
Page 16 and 17: The playback toolbar also appears t
Page 18 and 19: © Sony PSE 2004This document is in
Page 20 and 21: 18. For this example, we have chose
Page 22 and 23: 24. With the settings complete, the
Page 24 and 25: 5. Copy the serial number displayed
Page 26 and 27: 9 Monitors plus a Hotspot monitorAc

Sony RealShot Manager Quick Set Up Guide

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?