Operating manual No. 677-1 USA

2.3.4 Lighting cable connectionEstablish the connection between tractor and swatherwith the 7-cord cable provided.Check that the lighting is functioningproperly.2.3.5 Universal drive shaft connectionConnect the universal drive shaft to the PTO shaft andsecure the guard tube with the chain against following-on.(Wide angle on the implement)• Make sure that the universal driveshaft is the correct length when changingtractors! (see Chapter 2.3.5)KS-0-0152.3.6 Length adaption• During all care, maintenance, repair and assembly work on the rotary swather, switch offthe PTO. Shut down the engine, Remove the ignition key. Secure tractor and rotary swatheragainst rolling away!• Take apart the universal drive shaft.• Clip one half (1) and (2) onto the tractor and theother to the implement.(The wide angle coupling must be installed on theimplement. Note the labeling on the universal driveshaft.)• Move the rotary swather to the position where theuniversal drive shaft is at its shortest. (straight ahead)• The rest of the procedure can be found in themanual provided by the universal drive shaftmanufacturer.18Check the slewing range and clearancefor the universal drive shaft! Contactbetween the universal drive shaft andtractor or implement will result indamage. (e.g. hitching device, draw bar)12KS-0-017