Operating manual No. 677-1 USA

3.3 Converting from transport to workingpositionTurn the internal lateral guard bars (1) at the front leftandright-hand sides of the machine, by 90° inwardsinto the working position and lock with retaining pins(2). Secure retaining pin with spring pin.Before lowering the swather disk, makesure that the lateral guard bars (1) areturned inwards and no-one is within theslewing range of the swather disks!21Do not run the swather disks in thetransport position or with retractedguard bar!KS-0-103Swadro 651Insert switch cock for the hydr. actuation of the swatherin the holder on the tractor.Turn switch cock to central position (see adjacent.graphic). Release the lock by actuating the tractorhydraulics (lift). Release the lock actuating cable andhold in place and slowly lower the swather disks byactuating the hydraulics (lower). Release the actuatingcable again.Tine attachment (see Chapter 2.5.2 Tine attachment)1KS568001Swadro 761 mechanic version• Insert switch cock for the hydr. actuation of theswather in the holder on the tractor.• Open control valves (1) and (2).• Release the lock by actuating the tractor hydraulics(lift).• Release the lock actuating cable and hold in placeand slowly lower the swather disks by actuating thehydraulics (lower).• Release the actuating cable again.• Tine attachment (see Chapter 2.5.2 Tineattachment)21KS-761-00522