Operating manual No. 677-1 USA

4.3 Setting the working widthSwadro 761 mechanic versionThe desired working (raking) width can be preselectedby fitting pin (2) to one of the holes of the inner wing.1KS-761-009_1Close control valves (1) and (2).Open control valve (3).Before lowering the rotors to working position, extendthe rotor carrier arms up to the limit stop using thetractor hydraulics.213Swadro 761 electric versionThe working width of the swather arms is adjusted viatwo hydraulic cylinders.KS-761-003Switch on operation operation.The side to be adjusted is activated by turning Switch 5to the right or left.Then move the right- or left-hand deployment arm in therequired direction.354The working width of the swather arms should beadjusted during use.26Turn Switch 5 back to the neutral position (centralposition) once the procedure is complete and switch offoperation1MB KKRONEKS-0-102The distance from swather disks to the swath former:much feed = large distancelittle feed = small distanceThe forward speed depends on the working pattern =tidy tine work with good swath formation.30When initially actuating the width adjustmentor after prolonged breaks (e.g.winter storage), fully extend swatherdisks and put the tractor valves underpressure for at least 15 secs, so that thehydraulic accumulators on the adjustingcylinders are filled.