Trendsetter NEWS SA - Kodak

14 Chapter 2 —System OverviewEnvironment SpecificationsThe Trendsetter NEWS SA should be installed in a clean prepress area, inaccordance with the Trendsetter NEWS Family Site Preparation document(73-3363). Ensure that the operating environment and connectionrequirements are observed when your output device is installed and in use.The operating environment requirements for the Trendsetter NEWS SAare:• Temperature: 17°C–30°C (63°F–86°F)• Relative humidity: 20 percent to 70 percent RH, non-condensingFor information on noise emissions in an office environment, see NoiseEmissions on page 94.Required Operating ConditionsBecause the output device uses a thermal exposure head and imagesthermal plates, it does not require darkroom conditions.Maintenance SuppliesItemFiltersDebris FiltersDescriptionA number of filters are used in the output device to maintain the airquality. Use only Creo-authorized filters. Your output device may notoperate properly if you use a substitute or unauthorized filter. SeeReplacing Air Supply Filters on page 38 for more information.Depending on the type of plates they use, some Trendsetter NEWSmachines are equipped with Debris Removal Systems. See Replacing theUniversal Debris Removal Cabinet Filter on page 47 for moreinformation.WARNING: Particulate emissions that are not properly filtered can endangeryour health. For a list of airborne emissions that pertain to the plates you areusing, see the manufacturer’s MSDS or contact the manufacturer or distributordirectly.