Trendsetter NEWS SA - Kodak

Cleaning the Interior of the Output Device 35To replace the power box panel:1. Lift the panel and align the locating holes on the panel with thelocating pins on the output device. Lower the bottom of the panel ontothe pins (see Figure 14 on page 34 for an example of how to do this).2. Press the panel against the device frame, and then push the upperpanel corners in until you hear both latches click.Ensure that both power box panel latches are locked.3. Turn the power for the output device on.Cleaning the Interior of the Output DeviceCleaning the Edge Detection StripYou should perform routine maintenance on interior areas of the outputdevice regularly as outlined in Table 2 on page 27.WARNING: Do not let water or other liquids run freely into the output device.This can result in serious injury from electrical shock as well as damage to youroutput device.To register an image to the edge of a plate, the output device uses an edgedetection algorithm. This algorithm relies on a 741-mm (29.2") strip thatis set into the surface of the drum inside the output device, beside theleading-edge clamps. This strip is black and non-reflective.You must clean the edge detection strip every three months to avoid falseedge detections.