Trendsetter NEWS SA - Kodak

Replacing Air Supply Filters 41To inspect the filters:1. Ensure that the output device is not imaging plates.2. Turn the red air shutoff valve clockwise to the Off position to shut offthe compressed air supply. See Figure 18 on page 42.WARNING: Failure to remove air pressure from the output device beforeinspecting an air filter will result in the following:1) It will cause high-pressure air to be present in the filter elements andbowl, making disassembly difficult and dangerous, resulting in possibleserious injury from flying parts.2) It will cause a very loud noise that could cause moderate injury bydamaging your hearing.3. Shut down the output device.See Shutting Down the Trendsetter on page 19.4. Pull down the black tab on the front of the filter bowl for one of thefilters. This releases the lock on the filter bowl. See Figure 19 onpage 43.At the same time, rotate the filter bowl a quarter turn left and pull thefilter bowl down to remove it.5. Check the filter bowl for any damage or deterioration (cracks orcrazing).Contact your authorized service representative if replacement isnecessary.6. Check for water or oil in the filter bowl.If there is water or oil in the filter bowl, wash it with mild soap andwarm (not hot) water and contact your authorized servicerepresentative to have the air supply inspected.7. Reinstall the filter bowl.8. Repeat steps 4 through 7 for the other filter.9. Turn the red air shutoff valve counter-clockwise to the On position toturn the compressed air supply back on. See Figure 23 on page 45.The air pressure gauge should read approximately 90 psi. If it does not,adjust the external air supply regulator.