Trendsetter NEWS SA - Kodak

Plate Registration 232. Wearing gloves, grasp the edges of the plates. Lift the plates upwardsand carefully remove them from the load ramp.CAUTION: Wear protective gloves when handling plates. Plate edges canbe sharp. Failure to wear protective gloves can result in injury.Plate RegistrationPlate Bending and PunchingMedia alignment labels should be affixed to the load ramp of your outputdevice during installation. If they were not, you can affix the labels to theload ramp yourself (with the assistance of your authorized servicerepresentative). These labels act as guidelines to help you align the platesduring loading. The output device’s laser does the more preciseregistration. The laser beam corrects the registration to within 15 mm ifyou:• Load the plates to within ±3 mm (0.125") of the correct position onthe load ramp. If affixed, the media alignment labels can help youquickly identify the correct position.• Ensure that the plates are resting on the registration pins at the base ofthe load ramp. These pins ensure that the plates register properly onthe drum.Performing these steps can result in faster overall imaging time, asdetection of the plate edge occurs more quickly.Ensure that your existing plate bending and punching equipment isconfigured to match registration points on your output device. See theTrendsetter NEWS Family Site Preparations and Requirements document(Creo document number 73-3363).For additional information, contact your authorized servicerepresentative.