XG-V10XU - diagramas.diagram...

XG-V10XUNo. Adjusting point Adjusting conditions Adjusting procedure12 Video AGCadjustment1. Feed the split color bar signal.2. Select the following groupand subject.Group : VIDEO1Subject : AGCMake sure there are somebit dropouts on the screen.» Using the set’s control switch or the remotecontroller’s button, adjust the setting so that the100% white signal has some bit-less.13 Video tintadjustment1. Feed the split color bar signal.Select the followinggroup and subject.Group : VIDEO1Subject : TINT2. Connect the oscilloscope topin (4) of P801.» Using the set's control switch or the remotecontroller's button, adjust the setting so that the –(B–Y) waveform runs straight downhill.14 NTSC colorsaturationadjustment1. Feed the split color bar signal.2. Select the following groupand subject.Group : VIDEO1Subject : N-COLOR3. Connect the oscilloscope topin (1) of P801.» Using the set’s control switch or the remotecontroller’s button, adjust the setting so that theamplitude between the 100% white and red levelsbe 0.20 ± 0.02 Vp-p.100% White Red15 PAL colorsaturationadjustment1. Feed the PAL color bar signal.2. Select the following groupand subject.Group : VIDEO1Subject : P-COLOR3. Connect the oscilloscope topin (1) of P801.» Using the set's control switch or the remotecontroller’s button, adjust the setting so that theamplitude between the 100% white and red levelsbe 0.36 ± 0.02 Vp-p.100% White Red16 SECAM colorsaturationadjustment1. Feed the SECAM color barsignal.2. Select the following groupand subject.Group : VIDEO1Subject : S-COLOR3. Connect the oscilloscope topin (1) of P801.» Using the set's control switch or the remotecontroller’s button, adjust the setting so that theamplitude between the 100% white and red levelsbe 0.50 ± 0.02 Vp-p.100% White Red32