XG-V10XU - diagramas.diagram...

XG-V10XUNo. Adjusting point Adjusting conditions Adjusting procedure25 White balancechecking andreadjustment1. For the adjusting conditions,refer back to ItemNos. 8, 19 and 24 for theRGB, Video and DVD inputs,respectively.DTV input1) Feed the 720P SMPTE(color difference) signal.If out of spec, take thereadjustment step below.2) Select the followinggroup and subjects.Group : DTVSubject : CR-OFFSETCB-OFFSET26 Set-up 1. Select the following.Group : VIDEO 1Subject : SET UP BSET UP C» Make sure the white balance is the same as onthe monitor screen. To obtain the specified whitebalance, readjust the RGB, Video and DVD inputsin this order.» Make sure the SET UP B and SET UP C settingsare 6 and 1, respectively.27 Color-relatedperformancechecking1. Feed the color bar signal. » Select the process mode L1. Check the Color andTint settings.28 Video-relatedperformancechecking1. Feed the monoscope patternsignal.» Select the process mode L2. Check the Picture,Brightness and Sharpness settings.29 Audio-relatedperformancechecking1. Feed the stereo audio signal.» Select the process mode L3. Check the Bass,Treble and Balance settings.30 RGB-relatedperformancechecking1. Feed the RGB signal. » Select the process mode L4. Check the Picture,Brightness, Red, Blue, Clock, Phase, H-Pos andV-Pos settings.31 Off-timer performancechecking32 Thermistorperformancechecking» Select the process mode OFF. Make sure that theoff-timer starts with "5" (minutes) onscreen andcounts down minute by minute each second, andthat the set turns itself off with "0" (minutes)onscreen.» Get the thermistor status list displayed onscreen.33 Auto syncperformancechecking1. Feed the phase check patternsignal.» In the VGA, SVGA, XGA, SXGA and UXGAmodes, make sure the Clock, Phase, H-Pos andV-Pos settings can be automatically adjusted.35