XG-V10XU - diagramas.diagram...

XG-V10XUNo. Adjusting point Adjusting conditions Adjusting procedure34 Lens performancechecking» Using the set's control switch or the remote controller,make sure the focus, zoom, keystone and lensshift actions are as specified.35 Delivery settings1. When the S4 delivery settingshave been made, theSET-UP signal is acceptable.If the process mode iscalled up again, however,the SET-UP signal is notautomatically accepted. Insuch case, select Group:VIDEO1 and Subject: SETUP, change the SET UPsetting from 0 to 1, and exitfrom the process mode. Ormake the S4 delivery settingsagain.» Make the following settings.ProcessadjustmentRemote controllersettingS4 "Delivery setting 4"The methods of color correction adjustment, after LCD panel is replaced.When not use color correction system.No. Adjusting point Adjusting conditions Adjusting procedure1 Color correction 1. Make the following choice. » Make the following setting.RestGroup : NOKOSubject : CCSubject : CCSetting : 0 (color correction OFF)2 Saw-tooth waveCorrection (G),(R)1. Feed the gray only RGBcolor signal. (XGA 60Hz)2. Check for uneven color spoton the screen.3. Make the following choice.Group : NOKOSubject : NOKO-GChoose the subject NOKO-R for the R Color.» If the color is irregular, adjust the setting NOKO-Gor NOKO-R to minimize the right-hand and left-handcolor irregularity.» If there is no color irregularity, turn off the saw-toothcorrection using SW4201 (green) and SW4202 (red).36