XG-V10XU - diagramas.diagram...

XG-V10XUNo. Adjusting point Adjusting conditions Adjusting procedure17 Video inputpanel signalamplitudeadjustment1. Feed the NTSC 10-stepsignal.2. Select the following groupand subjects.Group : VIDEO2Subject : R1-GAINB1-GAIN3. Connect the oscilloscope topin (1) (for R) of P1001 andpin (3) (for G) of P1001.4. Similarly connect the oscilloscopeto the following forthe B color.Pin (5) of P1001 for BPin (3) of P1001 for G» Select R1-GAIN. Adjust the setting so that the Rsignal amplitude and the G signal amplitude bethe same.» Do the same for the B color.18 Video whitebalance adjustment19 DVD contrastadjustment20 DVD tint adjustment1. Feed the NTSCmonoscope pattern signal.2. Select the following groupand subjects.Group : VIDEO2Subject : R1-BLKB1-BLK1. Feed the 100% color barsignal of the 480I componentsignal to the G (Y) inputterminal on the BNCsocket.2. Select the following groupand subject.Group : DVDSubject : CONTRAST1. Feed the 100% color barsignal of the 480I componentsignal to the Y, Pb andPr input terminals on theBNC socket. For the Y signal,feed the sync signalonly.2. Select the following groupand subject.Group : DVDSubject : TINT3. Connect the oscilloscope topin (2) of P801.» Using the set's control switch or the remotecontroller's button, adjust the setting so that thewhite balance be the same as on the monitorscreen.» Using the set's control switch or the remotecontroller's button, adjust the setting so that the100% white signal has some bit dropouts.» Using the set's control switch or the remotecontroller’s button, adjust the setting so that the(B–Y) waveform runs straight uphill.With the above adjustment completed, get thesetting 3 points down.33