Smart Programmer - UK

SEKOSMART- Programmer- Laundry system1Contents of thepackage2Presentation3INItialize theprogrammer4Entering theparameters6.2 Receiving the data in the programmerTo RECEIVE the data residing in the Memory Card, select the Communications menu “COM“ thenselect the Memory Card menu “MEM”, then “Rx”; the following message will appear on the display:PaSsword0000Enter the PaSsWord; if no PaSsWord has never been set, type “0000”.If you do not wish to receive the data then press the key [ESC].Wrong MemoryIf the display indicates see point 6.55ProgrammingIf the display indicatesReceiveWait …wait until the following appears6Programmingthe Memory Card• Sending data tothe MemoryCard• Receiving thedata in theprogrammer• Password• Consumptionstatistics• Troubleshootingguide7Examples ofprogramming8Switching theprogrammer onand off9Connecting theprogrammer to aPC or to theConsoleThis confirms that receipt of the data has been successfully completed.6.3 PasswordSMART 1.0 (IT)PRG PAR COM INIThe password is always active, and therefore even if it has never been set it has a default value, whichis “0000”To change the PaSsWord, select “KEY” from the Communications menu; the following message willappear on the display:PaSsWord0000Enter the new PaSsWord, then confirm by pressing [Enter].To return to the Communications menu press [ESC].To activate the new key it is necessary to carry out a transmission (see point 6.1).Comunic. ErrorIf the display indicates see point 6.5 WARNING: It is not possible to change the PaSsWord without knowing the active one.When the following message appears on the display:PaSsWord0000Enter the four correct digits and press [Enter] to confirm. If they are correct, the operation will continue,otherwise the following message will be displayed for a few seconds:Wrong MemorySmart programmer Version 3.0 Code n° 0000136346 19