Dimensional Metrology - Procontrol AMC

fixed gauges for plain bores and shaftsPlug Gauges type 101–DIN 2245101GC–Go end chrome101LS–Special steelCylindrical Plug Gauges–Overview101HC–hard chrome plated101LS101GLS101ALS101GC101HC101GHC101AHCCylindrical plug gauge in special steel (Go and NoGo gauge)Cylindrical Go gauge in special steelCylindrical NoGo gauge in special steelCylindrical Plug Gauge: Go end in hard chrome, NoGo end in special steelCylindrical plug gauge in hard chrome (Go and NoGo gauge)Cylindrical Go gauge in hard chromeCylindrical NoGo gauge in hard chrome101TIN-G–Go end TiN treatedTechnical SpecificationsMaterial High-tensile special steel (LS)101TiN-GCylindrical Go gauge with coating of TiN, and NoGo gauge in special steelCylindrical Plug Gauges from Ø 0.2 to Ø 2 mm, see type 103When ordering flattening or marking, this should be ordered separatelyaccording to following order no.:OptionOrder no.Flattening: LSV5-30 (for gauges between Ø 5 and 30 mm)LSV30-50 (for gauges between Ø 30 and 50 mm)LSV50-70 (for gauges between Ø 50 and 70 mm)LSV70-100 (for gauges between Ø 70 and 100 mm)Marking: Marking (marking on handle, max. 12 characters)Meas surfaces Hardened, tempered, ground and lapped.Hard chrome plated or with a coating of TiNManuf. tol Acc. to DIN 7162 and 7164Applications - for checking of respectively, lower andupper, tolerance limits of bores- Go and NoGo ends are replaceable,- above Ø 40 mm the gauge is designedas a measuring disc, which may be turnedaround when worn out on one side.SizeØ mm 101LS- 101GC- 101HC- 101TiN-G-101GLS-101ALS-101GHC-101AHC-2; 2.2; 2.5; 2.8 - – – - – –3; 3.5; 4 -–– - – –4.5; 5.0 - 10.0 - – – – – –11.0 - 14.0 - – – – – –15–18 - – – – – –19–24 - – – – – –25–30 - – – – – –31–40 - – – – – –41–50 - – – – – –51–60 - – – - – –61–70 - – – - – –71–80 - – – - – –81–90 - – – - – –91–100 - – – - – –46Contact us at info@cej.se • Phone +46 (0) 16 15 06 40 • Fax +46 (0) 16 15 06 59