Dimensional Metrology - Procontrol AMC

screw gauges for threaded bores and shaftsOverviewGo NoGo Screw Thread Plug GaugesArticle groupFeaturesMaterialThread profileApplications145 Go NoGo thread plug gaugeHandle with two plugs (Go and NoGo).High-tensile special steel, hardened, tempered, ground and fine lapped.The Go side has a complete thread profile, the NoGo side has a shortened thread profilewith fewer threads.The Go thread gauge is used to test the effective mean diameter of the go side.The NoGo thread gauge is used to test the upper limit measure of the mean diameter.Go and NoGo Thread Plug GaugesArticle group 160 Go Thread GaugeFeatures Handle with one (Go) thread gauge plug. In other respects as article group 145.Article group165 NoGo Thread GaugeFeatures Handle with one (NoGo) thread gauge plug. In other respects as article group 145.Article groupApplicationsArticle groupApplications160GE Master thread gauge for Go thread ringTesting of new thread rings and work gauges.165AB Master thread gauge for worn Go thread ringTesting worn screw thread rings.Go and NoGo Screw Thread Ring GaugesArticle groupMaterialThread profileApplications170G Go thread ringHigh-tensile special steel, hardened, tempered, ground and fine lapped.The Go side has a complete screw thread profile. Mean and inner diametercorresponds to the largest measure of the tested outside thread.The Go thread gauge is used to test the effective mean diameter of the go side.Article groupMaterialThread profileApplications170A NoGo thread ringHigh-tensile special steel, hardened, tempered, ground and fine lapped.The NoGo side has a shortened thread profile with fewer threads.The NoGo thread ring is used to check the lower limit measure of the mean diameter.Screw Thread Setting GaugesArticle groupFeaturesMaterialThread profileApplications180 Screw thread setting gaugeHandle with two plugs (Go and NoGo).High-tensile special steel, hardened, tempered, ground and fine lapped.The Go side has a complete thread profile, the NoGo side has a shortened threadprofile with fewer threads.Thread setting gauges are utilized as setting and testing gauges for Go/NoGocaliper thread gauges to test inner and outer diameters.Other GaugesArticle groupArticle group101K Core diameter gauge for the testing of the inner diameter of a nut thread.122A Go/NoGo caliper gauge for testing the outer diameter of a screw thread.Made to OrderMade to Order- intervening sizes- left-handed thread- other tolerances than the standard tolerances mentioned in the catalogue50Contact us at info@cej.se • Phone +46 (0) 16 15 06 40 • Fax +46 (0) 16 15 06 59