ARAG Skipper LT GPS Instrictions - Bargam UK

PROGRAMMING - MACHINES SETUP6.5.2 - GPS antennaFig. 33Within every item, active options are marked with .Antenna positionIndicate the position of the antenna with respect to the point where tractor is spraying (crop sprayingboom, spreader plate, etc.).In the example shown in Fig. 34, antenna A is installed in Front of the spraying boom B.Warning: Before setting this item, modify the Antenna distance (Fig. 35): if Antennadistance is zero, item Antenna position cannot be modified.Fig. 34Antenna distanceIndicate distance C between antenna and work point (Fig. 35).Depending on entered value, the displayed sketch will change accordingly.Fig. 35DGPSAllows you to enable the DGPS differential correction function (SBAS): SBAS differential correctionsignal is a free signal only available in some areas world-wide that ensures a higher work accuracy.WARNING: this function can only be used in Europe (EGNOS), United States of America(WAAS) and Japan (MSAS).Fig. 36Enabling / disabling the differential correction during the job could lead to a rather big measurementerror between the vehicle and the tracks sprayed until that moment (E in Fig. 36). The followingpasses will be correctly measured (equidistant one from the other).In the example shown in Fig. 36, press OK to continue job. It is recommended to perform a trackalignment JUST AFTER THIS, using function "Align" (par. 8.2.4 - F4 Align).Confirm access ordata changes.Scrolling menu items.Increase / decrease dataQuit the function ordata changesReset / disabledataShift thecursorPar.6.318