BOILERMATE BOILERMATE - Gledhill Spare Parts

1.0 DESIGN1.1 INTRODUCTIONThese instructions should be read inconjunction with the Installation and ServicingInstructions issued by the manufacturers ofthe heat source e.g. the boiler used.Any water distribution and central heatinginstallation must comply with the relevantrecommendations of the current version ofthe Regulations and British Standards listedbelow:-Gas Safety RegulationsBuilding RegulationsI.E.E. Requirements for Electrical InstallationsWater RegulationsBritish StandardsBS6798, BS5449, BS5546, BS5440:1, BS5440:2,CP331:3, BS6700, BS5258, BS7593 and BS7671.A competent person as stated in the GasSafety Regulations must install the BoilerMateheating system. The manufacturer’s notesmust not be taken as overriding statutoryobligations.The BoilerMate 2000 is only suitable for usewith an open vented central heating system.The BoilerMate 2000 is not covered by sectionG3 of the current Building Regulations and istherefore not notifiable to Building Control.The information in this manual is provided toassist generally in the selection of equipment.The responsibility for the selection andspecification of the equipment must howeverremain that of the customer and any Designersor Consultants concerned with the design andinstallation.Page 3Please Note: We do not therefore accept anyresponsibility for matters of design, selectionor specification or for the effectiveness of aninstallation containing one of our productsunless we have been specifically requestedto do so.All goods are sold subject to our Conditionsof Sale, which are set out at the rear of thismanual.In the interest of continuously improvingthe BoilerMate range, Gledhill Water StorageLtd reserve the right to modify the productwithout notice, and in these circumstancesthis document, which is accurate at the timeof printing, should be disregarded. It willhowever be updated as soon as possible afterthe change has occurred.BOILERMATE 2000