BOILERMATE BOILERMATE - Gledhill Spare Parts

1.0 DESIGN1.2 TECHNICAL DATAStandard EquipmentThe standard configuration of the BoilerMate2000 is shown opposite. The Appliance ControlBoard (A.C.B.), mounted inside the appliance,controls the operation of the complete system.The A.C.B. is pre-wired to a terminal stripwhere all electrical connections terminate. Itis supplied with the following factory fittedequipment:-1. Boiler pump2. Domestic hot water primary(plate heat exchanger) pump3. Space heating pump4. Hard water appliance control board(A.C.B.)5. Electro-mechanical clock to control thespace heating (in conjunction with roomthermostat - if fitted)6. Plate heat exchanger7. DHWS temperature sensor8. PHE return sensor9. Store temperature sensor10. Y type strainer/flow regulator11. A feed and expansion cisterncomplete with ballvalve, overflowfitting and cold feed/open vent pipeworkassembly is supplied separately.Electro-mechanical clockprogrammerAppliance Control BoardA.C.B.Optional Equipment* A soft water model is available for areaswhere the hardness level is below 200p.p.m. (mg/ltr)* Flexible connectors for quickconnection to first fix pipe installation.For further details see 2.2 Installation,Pipework connections.* ‘Switch’ emergency electrical back-upfor heating and hot water in the eventof a boiler fault.* A seven day digital clock/programmerto control the space heating (inconjunction with a room thermostat iffitted).* A kit to site the clock/programmerremotely.* A no clock option - because of thedesign of the appliance it should not benecessary to fit anything other than asingle channel clock to control theheating system.* Hot and cold water manifolds for use withplastic pipework.Digital clock programmer‘Switch’Page 6